MODEL F (CUT IN APPLICATION)
|
Step
|
Installation instruction
|
|
1.
|
Clean the area in which the loop is to be placed. |
|
2.
|
Lay out the loop in the desired pattern / configuration. NOTE: Laying the loop out symmetrically and evenly is best. |
|
3.
|
Using the loop for a template, mark out the line for slot cut. |
|
4.
|
Cut the lead-in slot first. Cut two sides perpendicular to lead-in slot next travelling 4"-6" (10-14 cm.) beyond the cut actually needed. |
|
5.
|
Cut the slots a minimum of 2 inches (50 mm.) in depth. |
|
6.
|
Over cut slots at corners by 4" - 6". |
|
7.
|
Prior to cutting the final slot (side), lay out the loop in the three slots already there and mark the final slot to be as precise as possible. |
|
8.
|
Remove loop and cut the final slot. |
|
9.
|
VERY IMPORTANT!!! Clean any debris out off the slots with an air hose. Once clean, remove any water or moisture. |
|
10.
|
Snap Quintex tees over the corners. Tape securely together!!! |
| 11. | SEE DRAWING BELOW!!!!! |
